Buy Johnson Outboard Parts

Announcement

Collapse
No announcement yet.

water pumping issues

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • water pumping issues

    I have an 83 25hp evinrude, just bought it, i went to replace the impeller because i didn't see water pumping through the pee hole during the test run, compression was on point, when reassembly i noticed the brass tube that pumps water to the power head was not making a seal at all! Should i continue trouble shooting this, power head shows no signs of over heating, "paint discoloration".... is there a part missing or worn out?

  • #2
    Sounds like there is a good chance that #321513, water tube guide, has been "smoked" from out of your exhaust housing. Unfortunately, this part is no longer available - unless you fine a Johnson/Evinrude dealer like Wills Marine in Pensacola, or some other J/E dealer who may still have one in stock - Maybe Stone's in Houston, TX.
    Your other option is to replace your 1983 exhaust housing with one from a newer motor, such as a 1987 model, that does not require this guide.
    Either way, you will have to pull your entire powerhead to get to the issue on the bottom of your powerhead.

    Comment

    Working...
    X