Howdy:
Thought I would ask here before I screwed something up.....manual tilt on my 1990 48HP has gone belly-up....the release actuator is frozen; I am assuming the cartridge is dry....the release clip that attaches to the cable and release handle wasn't broken until I reset it down on the cable and then, of course, it broke. I noticed last fishing season, it seemed harder to raise the engine , ..Any time I tried to find how to recharge the canister, I met either a dead end with a dealer who wanted to replace the assembly, at the 150 dollar price point, or I found the part for 150 dollars plus shipping....again, no info on rebuilding the canister or adding fluid to it.....of course, now it is do or die time......so any information is appreciated. Of course the hex bolt is frozen and the actuator on the canister takes a special tool to remove it.
Thanks in advance,
Bob
Thought I would ask here before I screwed something up.....manual tilt on my 1990 48HP has gone belly-up....the release actuator is frozen; I am assuming the cartridge is dry....the release clip that attaches to the cable and release handle wasn't broken until I reset it down on the cable and then, of course, it broke. I noticed last fishing season, it seemed harder to raise the engine , ..Any time I tried to find how to recharge the canister, I met either a dead end with a dealer who wanted to replace the assembly, at the 150 dollar price point, or I found the part for 150 dollars plus shipping....again, no info on rebuilding the canister or adding fluid to it.....of course, now it is do or die time......so any information is appreciated. Of course the hex bolt is frozen and the actuator on the canister takes a special tool to remove it.
Thanks in advance,
Bob
Comment